Windows Tools #

• Eclipse Embedded CDT like:eclipse-embedcpp-2023-09-R-win32-x86_64.zip
• gcc-arm-none-eabi like:gcc-arm-none-eabi-10.3-2021.10-win32.exe
• Jlink driver like:JLink_Windows_x86_64_V752.exe (Depends on your JLink tools on hand)

Debugging Procedure #

• The project to be debugged imports eclipse (Optional):

• Click Run on the menu bar -> Debug Configurations…-> double click GDB SEGGER J-Link Debugging,New debug entry will be created:

• Configure the “Main” page of the new Debug entry：
  • Click the button of “Browse…” and then select the file of “.elf” which will be debugged.
  • Select “Use Active” as the “Build Configuration “

• Configure the “Debugger” page：
  • Click the top button of “Browse…” to select the “JLinkGDBServerCL.exe”
  • Set “Device name” as “ARM9”
  • Select “JTAG” as the “Interface”
  • Deselect the “Verify downloads.”
  • Click the bottom button of “Browse…” to select the “arm-none-eabi-gdb.exe”

• Configure the “Startup” page：
  • Set “Set program counter at (hex)” to 0
  • Set a breakpoint at “entry_main”

• The “Source” page uses the default configuration：

• The “Common” page uses the default configuration：

• Click the “Debug” button to enter the Debug mode：

The following interface is displayed after the startup：

• Using button like “Step Into”、”Step Over”、”Step Return” to do the debug